Most water heater manufacturers recommend draining the water heater tank every 6 or 12 months. Flushing the tank helps to remove sediment that can accumulate over time at the bottom of the tank. The sediment is mostly made up of minerals and other particles. If your home has hard water, sediment is likely to accumulate faster.
As the sediment builds up it creates an insulating layer between the burner at the bottom of the tank and the water. The burner has to run longer to heat the water, reducing the water heater's efficiency and shortening its lifespan. Flushing the water heater tank regularly will remove the sediment before it can significantly reduce the the efficiency of the burner.
Flushing a water heater is straightforward process, but you should always consult with the owner's manual for details on your particular make and model. It's also a good idea to know where your home's main water shut-off valve is located, should there be a problem during the process.
Steps to Flush the Water Heater Tank
1. Shut off the water supply - Locate the cold water supply valve at the top of the water heater and turn it to the off position.
2. Turn off the water heater - If you have a gas water heater, simply turn the thermostat knob to the “pilot” setting. If the water heater is electric, turn off the power at the breaker panel.
3. Attach a garden hose to the drain valve located near the bottom of the tank. Place the other end of the hose near a floor drain, in a bucket (have several large buckets to empty into and rotate them if needed) or outside the home.
CAUTION: Even though a water heater may be off for hours, the water in the tank may still be hot enough to scald.
4. Open a hot water tap - Open a hot water tap on a floor above that is nearest the water heater. This will relieve pressure in the system, helping the water drain from the tank.
5. Open the drain valve - After all the water has drained from the tank, turn the cold water supply at the top of the tank back on for a moment. This will clear out any remaining sediment. Repeat this step until the water runs clear.
When you're finished draining the tank, return it to operating condition by following these steps:
1. Close the drain valve.
2. Remove the hose.
3. Turn on the cold water supply to refill the tank.
4. Return to the hot water tap you opened earlier. Once cold water begins to flow from the tap, turn it off.
5. Turn the gas valve back on from the pilot position or turn electricity back on to the tank.
6. Check the valve opening to ensure it's not leaking.
IMPORTANT: Always read and follow all manufacturer’s directions and warnings for your particular water heater. Some water heater tanks must be completely full to avoid damage to the gas burner or heating elements.
Need help maintaining your water heater? Call Grand Lake Plumbing, we can help.